Linerless Setting (Linerless) - Toshiba B-EP Series Key Operation Specification

6.6.2.2.4

Linerless Setting (LINERLESS)

This setting is for using a linerless label.
L I N E R L E S S
L I N E R L E S S
Default value: OFF (Linerless setting is disabled.)
<Commentary>
When linerless setting is enabled:
On V1.0D or earlier, no back feed is performed.
On V1.0E or later, the back feed amount becomes less, compared to when the linerless setting
is disabled, as described below. Accordingly, an unprintable area increases at a print start
time.
When linerless mode is turned off (common to the 2-inch and 4-inch heads)
Command mode
TPCL
Label
Receipt
ECR/POS
When linerless mode is turned on:
(2-inch head)
Command mode
TPCL
Label
Receipt
ECR/POS
O F F
[PAUSE]
O N
[PAUSE]
(Unprintable area when starting printing immediately after a back feed)
B-SP series compatible mode ON
7.3 mm (3.0 mm)
Back feed fine adjustment enabled
7.3 mm (3.0 mm)
(Unprintable area when starting printing immediately after a back feed)
B-SP series compatible mode ON
7.3 mm (3.0 mm)
Back feed fine adjustment enabled
7.3 mm (3.0 mm)
- 73 -
Linerless setting is disabled.
Linerless setting is enabled.
Back feed amount
B-SP series compatible mode OFF
9.3 mm (1.0 mm)
Back feed fine adjustment disabled
5.0 mm (5.3 mm)
2.0 mm
Back feed amount
B-SP series compatible mode OFF
7.3 mm (3.0 mm)
Back feed fine adjustment disabled
5.0 mm (5.3 mm)
2.0 mm