Test Print Condition Parameter Setting (Print Condition) - Toshiba B-EP Series Key Operation Specification

6.6.5.2.2

Test Print Condition Parameter Setting (PRINT CONDITION)

P R I N T C O N D I T I O N
I S S U E C O U N T
S E N S O R
T Y P E
L A B E L L E N .
P A P E R
< 5 > T E S T
S L A N T L I N E ( 1 D O T )
<Supplemental Explanations>
When the [FEED] key is pressed, the menu moves in the opposite direction from when the [PAUSE]
key is pressed.
When the [FEED] and [PAUSE] keys are simultaneously pressed, the display returns to the system
mode menu.
When the [FEED] key or [PAUSE] key is pressed for 0.5 seconds or more during this setting, repeat
mode is enabled and the key pressed is repeatedly entered.
The change in the parameter setting becomes effective when the [POWER] key is pressed after
setting, then stored in the backup memory.
The default value at power on is PRINT CONDITION (test print condition parameter setting).
[POWER]
[POWER]
N O N E
[POWER]
A U T O
[POWER]
6 3 m m
[POWER]
N O F E E D
[POWER]
P R I N T
[POWER]
- 115 -
Print condition parameter setting
1 Issue count
Sensor setting
Print type setting (BATCH/STRIP)
Label length setting
Paper feed mode
Test print mode
1-dot slant line print mode
Moves to the test print mode selected.