Strip Position Fine Adjustment (Peel Adj.) - Toshiba B-EP Series Key Operation Specification

6.6.4.2.6

Strip Position Fine Adjustment (PEEL ADJ.)

PAUSE
2.35 mm
<Supplemental Explanations>
(1) When the [FEED] key is pressed, the menu moves in the opposite direction from when the
[PAUSE] key is pressed.
(2) When the [PAUSE] key is pressed while the [FEED] key is held down, or when the [POWER] key
is pressed for 3 seconds or more, the display returns to the system mode menu (ADJUST SET).
(3) When the [PAUSE] key or [FEED] key is pressed for 0.5 seconds or more during this fine
adjustment setting, repeat mode is enabled and the key pressed is repeatedly entered.
(4) The change in the fine adjustment value becomes effective when the [POWER] key is pressed
after setting, then stored in the backup memory.
(5) The printer is controlled by the total amount determined by this command and the Position Fine
Adjustment command sent from the PC (strip position fine adjustment value). However, the
maximum value is –2.0 mm to +3.0 mm.
(6) The strip position fine adjustment value up to V1.0C is valid only when no print position fine
adjustment value is set (value: 0).
(7) The factory default value is +0.0 mm.
-2.0mm
+0.0 mm
-1.9mm
-0.1mm
+0.0mm
+0.1mm
+3.0 mm
+2.9mm
+3.0mm
-2.0 mm
Paper feed direction
Regardless of gap length, the stop position in strip issue mode
is designed in a manner so that printing stops when the
distance from the top edge of the strip shaft to the trailing edge
of the label is 2.35 mm, if print position fine adjustment value is
not set. [up to V1.0C]
If the above-mentioned stop position is not proper, the stop
3 mm ~ 7 mm
position should be adjusted using the stop position fine adjust
function for the strip issue.
Strip stop position (top edge of strip shaft)
Strip stop position (top edge of strip shaft)
Strip stop position (top edge of strip shaft)
- 108 -