Toshiba B-EP Series Key Operation Specification page 83

(4-inch head)
Command mode
TPCL
Label
Receipt
ECR/POS
When linerless setting is enabled, the printer operates with the AUTO setting although AUTO1 or
AUTO2 (supported on V1.0E or later only on the B-EP2DL) is selected in head division setting.
When linerless setting is changed from OFF (disabled) to ON (enabled), back feed restriction is
automatically turned OFF (back feed not restricted). [on V1.0E or later]
When linerless setting enable/disable setting is changed from ON (enabled) to OFF (disabled),
back feed restriction is automatically turned ON (back feed restricted). [on V1.0E or later]
When linerless setting is enabled, whether or not to perform a back feed is determined depending
on back feed restriction setting regardless of sensor setting. [on V1.0E or later]
<Supplemental Explanations>
When the [FEED] key is pressed, the menu moves in the opposite direction from when the [PAUSE]
key is pressed.
When the [FEED] and [PAUSE] keys are simultaneously pressed, the display returns to the system
mode menu.
When the [FEED] key or [PAUSE] key is pressed for 0.5 seconds or more during this parameter
setting, repeat mode is enabled and the key pressed is repeatedly entered.
The change in the parameter setting becomes effective when the [POWER] key is pressed after
setting, then stored in the backup memory.
(Unprintable area when starting printing immediately after a back feed)
B-SP series compatible mode ON
5.3 mm (5.0 mm)
Back feed fine adjustment enabled
5.3 mm (5.0 mm)
- 74 -
Back feed amount
B-SP series compatible mode OFF
5.3 mm (5.0 mm)
Back feed fine adjustment disabled
5.0 mm (5.3 mm)
2.0 mm