Playback - Basics; Playing Back A Tape - Sony Handycam DCR-TRV60 Operating Instructions Manual

— Playback – Basics —

Playing back a tape

You can monitor the recorded tape on the LCD screen. If you close the LCD panel, you
can monitor the playback picture in the viewfinder. You can also control playback using
the Remote Commander supplied with your camcorder.
(1) Set the POWER switch to VCR while pressing the small green button.
(2) Press OPEN to open the LCD panel.
(3) Press
(4) Press
(5) Adjust the volume following the steps below.
1 Press FN to display PAGE1.
2 Press VOL. The screen to adjust the volume appears.
3 Press – (to turn down the volume)/+ (to turn up the volume).
4 Press
3
2
To return to FN
Press EXIT.
To stop playback
Press in the stop state.
To rewind the tape
Press in the stop state.
To fastforward the tape
Press in the stop state.
To view a still image (playback pause)
Press during playback. To resume playback, press
pause lasts for about five minutes, your camcorder automatically enters the stop state.
If you leave the power on for a long time
Your camcorder gets warm. This is not a malfunction.
to rewind the tape.
to start playback.
OK to return to PAGE1.
4 1
MEMORY/
NETWORK
5
– VOL
The bar indicator
again. When playback
VCR
OFF(CHG)
CAMERA
OK
+
39