Troubleshooting; Types Of Trouble And How To Correct Trouble - Sony Handycam DCR-TRV60 Operating Instructions Manual

— Troubleshooting —

Types of trouble and how to correct trouble

If you run into any problem using your camcorder, use the following table to
troubleshoot the problem. If the problem persists, remove the power source and contact
your Sony dealer. If "C:ss:ss" appears on the screen, the self-diagnosis display
function has activated. See page 191.
During recording
Symptom
START/STOP does not operate.
The power goes off.
The picture in the viewfinder is not
clear.
SteadyShot does not work.
The autofocusing function does not
work.
The picture does not appear in the
viewfinder.
A vertical band appears when you
shoot a subject such as lights or a
candle flame against a dark
background.
Cause and/or Corrective Actions
• The POWER switch is not set to CAMERA.
c Set it to CAMERA (p. 25).
• Your camcorder automatically turns off to prevent the
battery pack from running out and to protect the tape
when your camcorder has been in recording standby for
more than five minutes.
c Set the POWER switch to OFF (CHG) and then to
CAMERA.
• The tape has run out.
c Rewind the tape or insert a new one (p. 8, 39).
• The write-protect tab is set to SAVE >.
c Use a new cassette or slide the tab (p. 8, 195).
• The tape is stuck to the drum (moisture condensation).
c Remove the cassette and leave your camcorder for at
least one hour to acclimatize (p. 202).
• Your camcorder automatically turns off to prevent the
battery pack from running out and to protect the tape
when your camcorder has been in recording standby for
more than five minutes.
c Set the POWER switch to OFF (CHG) and then to
CAMERA.
• The battery pack is dead or nearly dead.
c Install a fully charged battery pack.
• The viewfinder lens is not adjusted.
c Adjust the viewfinder lens (p. 31).
• STEADYSHOT in
c Set it to ON (p. 174).
• The setting is the manual focus.
c Press FOCUS to enable the autofocus (p. 63).
• Shooting conditions are not suitable for autofocus.
c Adjust the focus manually (p. 63).
• The LCD panel is open.
c Close the LCD panel (p. 28).
• The contrast between the subject and background is too
high. This is not a malfunction.
is set to OFF in the menu settings.
(continued on the following page)
183