Sony Handycam DCR-TRV60 Operating Instructions Manual page 41

Playing back a tape
Using the Remote Commander
Press DATA CODE on the Remote Commander during playback.
The display changes as follows each time you press DATA CODE:
date/time t various settings (SteadyShot off, exposure, white balance, gain,
shutter speed, aperture value) t (no indicator)
To not display the various settings
Set DATA CODE in
The display changes as follows each time you press DATA CODE on the Remote
Commander:
date/time y (no indicator)
Various settings
Various settings show your camcorder's recording information when you recorded.
During recording, the various settings are not displayed.
When you use data code, bars (-- -- --) appear if:
– A blank portion of the tape is being played back.
– The tape is unreadable due to tape damage or noise.
– The tape was recorded by a camcorder without the date and time set.
Data code
When you connect your camcorder to a TV, the data code also appears on the TV
screen.
to DATE in the menu settings (p. 181).
41