Playback - Basics; Playing Back A Tape - Sony MICROMV DCR-IP5 Operating Instructions Manual

— Playback – Basics —

Playing back a tape

You can monitor the playback picture on the LCD screen. If you close the LCD panel,
you can monitor the playback picture in the viewfinder. You can also control playback
using the Remote Commander supplied with your camcorder.
(1) Install the power source and insert the recorded tape.
(2) Press OPEN to open the LCD panel.
(3) Set the POWER switch to VCR. The camcorder turns on and the VCR lamp
(4) Select
(5) Select
(6) Adjust the volume following the procedure below.
1 Select FN, then press the center z on the control button. The PAGE1 screen
2 Select VOL, then press the center z on the control button. The screen for
3 Select –/+, then press the center z on the control button repeatedly to adjust
(7) Select
38
lights up.
, then press the center z on the control button to rewind the tape.
, then press the center z on the control button to start playback.
appears.
adjusting the volume appears.
the volume.
– : to turn down the volume
+: to turn up the volume
You can adjust the volume by pressing b/B repeatedly after you select –/+.
OK, then press the center z on the control button. The PAGE1 screen
appears.
4
2
1
5 6
FN
– VOL
VOL bar
3
POWER
CAMERA
MEMORY/ (CHG)
NETWORK
OFF
VCR
ON
MODE
OK
+