Inserting A Scene From A Vcr - Insert Editing - Sony Handycam DCR-TRV60 Operating Instructions Manual

Inserting a scene from a VCR
– Insert editing
You can insert a new scene with sound from a VCR onto your originally recorded tape
by specifying the insert start and end points. Use the Remote Commander for this
operation.
Connections are the same as on page 89. Insert the cassette containing the desired scene
to insert into the VCR.
[A]
[B]
[C]
[A] The tape that contains the scene to be inserted
[B] The tape before editing
[C] The tape after editing
The POWER switch should be set to
Operate by touching the panel.
(1) On the VCR, locate just before the insert start point [a], then set the VCR to
playback pause.
(2) On your camcorder, locate the insert end point [c], then set it to playback
pause.
(3) Press ZERO SET MEMORY on the Remote Commander. The ZERO SET
MEMORY indicator flashes and the end point of the insert is stored in memory.
The tape counter shows "0:00:00".
(4) On your camcorder, locate the insert start point [b] and set your camcorder to
recording pause.
1 Press FN and select PAGE3.
2 Press REC CTRL.
3 Press REC PAUSE.
(5) First press X on the VCR, and after a few seconds press REC START on your
camcorder to start inserting the new scene with sound.
Inserting automatically stops near the zero point on the tape counter. Your
camcorder automatically stops recording and the zero point set with ZERO
SET MEMORY is cleared from memory.
[a]
[b]
.
[c]
91