Charging The Battery Pack - Sony Handycam DCR-TRV60 Operating Instructions Manual

Step 1 Preparing the power source

Charging the battery pack

Use the battery pack after charging it for your camcorder.
Your camcorder operates only with the "InfoLITHIUM" battery pack (M series).
See page 197 for details on "InfoLITHIUM" battery pack.
(1) Install the battery pack on your camcorder.
(2) Connect the AC Adaptor supplied with your camcorder to the DC IN jack with
(3) Connect the power cord to the AC Adaptor.
(4) Connect the power cord to a wall outlet.
(5) Set the POWER switch to OFF (CHG). Charging begins. The CHARGE lamp
5
CHARGE lamp
After charging the battery pack
Disconnect the AC Adaptor from the DC IN jack on your camcorder.
Note
Prevent metallic objects from coming into contact with the metal parts of the DC plug of
the AC Adaptor. This may cause a short-circuit, damaging the AC Adaptor.
When you use the AC Adaptor
Place the AC Adaptor near a wall outlet. While using the AC Adaptor, if any trouble
occurs with this unit, disconnect the plug from a wall outlet as soon as possible to cut
off the power.
16
the DC plug's v mark facing up.
lights up. When charging is completed, the CHARGE lamp turns off (full
charge).
VCR
OFF(CHG)
CAMERA
MEMORY/
NETWORK
2
3