Step 1 Preparing The Power Source; Installing Or Removing The Battery Pack - Sony Handycam DCR-TRV60 Operating Instructions Manual

Step 1 Preparing the power source

Installing or removing the battery pack

Be sure to set the POWER switch to OFF (CHG) before installing, removing or
exchanging the battery pack.
(1) Lift up the viewfinder.
(2) Slide the battery pack down until it clicks.
To remove the battery pack
(1) Lift up the viewfinder.
(2) Slide the battery pack out in the direction of the arrow while pressing BATT
down.
If you use the large capacity battery pack
If you install the NP-FM70/QM71/QM71D/FM91/QM91/QM91D battery pack on your
camcorder, extend and lift up the viewfinder and adjust the angle of it.
1
2
1
2
2
BATT release
button
15