Table of Contents
Advertisement
Step by Step Instructions
6.12
Battery Care
It is recommended to read Section
Important safety information is located there.
Propex IQ
operation, the battery status is shown on the device front panel as the color of the ON/
OFF/Standby button. See
The following notes will help you to ensure the battery provides a long service life:
•
If the battery LED on the device flashes red, there is less than 5 min of device
autonomy left. You must charge the device.
•
Do not charge the battery more than once a day. It is recommended that you charge
the device at the end of each day.
•
Charge the battery overnight after using Propex IQ
fully charged after up to 6 hours of charging.
•
Always fully charge the battery, i.e. until the battery LED stops flashing green and
turns steady green.
•
When the charger is unplugged, the device will go in active mode.
•
When the device is in standby mode and the charger is plugged, the device will start
charging.
•
When the device is turned off and the charger is plugged, the device will start
charging.
N°
A
Connect the charger (2) to the device (1) and plug it into the power outlet.
BENPPIQDFUWEB / Rev.04 / 08-2018
®
Apex Locator is powered by two AAA (1.2 V) Ni-MH batteries. During the
6.6 Description of the LED
1
3 Warnings
(Battery) before reading this section.
Colors.
®
Action
2
Apex Locator. The battery is
41/74
Advertisement
Table of Contents
