Table of Contents
Advertisement
11 Cleaning and care
11.1 Cleaning the outer surface
60
11
Cleaning and care
11.1
Cleaning the outer surface
Clean the outer surfaces at regular intervals with a mild, commercially
available cleaning agent.
11.2
Protection against medicaments
Due to their high concentrations and the substances they contain, many
medicaments can dissolve, etch, bleach or discolor surfaces.
NOTICE
Damage to the surface
Clean the surface immediately with a moist cloth and a cleaning
agent.
11.3
Cleaning the optics
The 3D camera system is a very sensitive optical device and must be
handled with the utmost care. It is not usually necessary to clean the
optical surfaces as these are located inside the device.
If, as an exception, cleaning is required, you can clean the optical
surfaces.
ü The unit is switched on at the main switch.
1. Switch to the scan phase in the inLab software.
2. Select "Capture Free" .
3. Place a sheet of paper on the work surface so that it is illuminated
by the blue projector lamp.
Ä The auto-focus function moves the scan element into the lowest
position
Ä Wait until the auto-focus movement has been completed.
4. Switch the unit off at the main switch.
5. Secure the main switch so that it cannot be switched back on
inadvertently (e.g. by another person).
Ä The blue light is no longer emitted from the opening of the
scanning element.
Ä You can view the scanning elements using a mirror or from
directly below (camera lens and projection lens).
6. Attempt to blow away the dirt. Use conventional photo bellows for
this.
7. If further cleaning is required, clean the optical surfaces using a
dust and lint-free soft cotton swab and a little ethanol (standard
alcohol for cleaning) or acetone.
8. Switch on the inEos X5 at the main switch and restart the software.
Dentsply Sirona
Operating Instructions inEos X5
64 17 096 D3586
D3586.201.01.16.02 2023-12
Advertisement
Table of Contents
