Part 5: Maintenance
5.3 Opening the Caps and Moving the Wiper Unit
The procedures for manually opening the caps and ink supply valves are presented
below.
The carriage lock pin and caps need to be released manually if moving the carriage
when the power is turned off. For details on the sensors and flags, refer to
DETECTION
5.3.1 Opening the caps and releasing the carriage lock pins
1) Remove the right side cover, right rear cover, and right upper cover.
2) From the right side, insert a long driver on top of the upper side plate of the purge
unit and push the long driver down while keeping it horizontal. This lowers the cap
and lock pin and allows the carriage to move.
Figure 5-40 Opening the Caps and Releasing the Carriage Lock Pins
FUNCTIONS.
Carriage motor
Long driver
Purge unit
Upper side plate
of the purge unit
5-36
W6200
Part 4: 5.
Carriage lock pin