Canon W6200 Service Manual page 145

Part 4: Technical Reference
c) Paper delivery
If auto cut is enabled when using roll media, the media is fed to the cut position
after printing and cut using the cutter. Then, the roll media on the platen is fed by
approximately 100 mm, and the cut roll media is pushed out. The discharged sheet
is stacked on the stacker with the printed side face down.
The roll media on the platen is returned to the print standby position.
In continuous banner printing with roll media, the paper is not cut and waits in
pause mode for maintenance operations such as cleaning.
The printed cut sheets stop on the platen, and a message is displayed when printing
is finished.
NOTE
The paper is ejected when the [Paper Source] button is pressed while the
printer is offline. However, the paper is not ejected if "Cutter disable" is set
in roll media mode.
4-36
W6200