Disassembly/Assembly Flowcharts For Major Parts - Canon W6200 Service Manual

Part 5: Maintenance

5.1.1 Disassembly/assembly flowcharts for major parts

Left nameplate (h2)
Left side cover (s2) (see p.5-14)
Rear left cover (s1, h1)
3
Left bottom cover (s2)
Pinch roller
pressure
4
sensor (s2, c1)
Upper rear cover (s3) (p.5-17)
Roll holder slot left
(s4)
Pinch roller pressure axis (s7)
Pinch roller unit
1
(s1) x 5
Paper feed guide (s2) x 2
Feed sensor (s1, c1)
LF_ENC cable (c1)
6
DC_L cable (c5)
DC_R cable (c8)
3
Feed roller sensor (c1, s1)
4
Feed motor support (s4, c1)
Feed motor (s4)
Symbol Meanings c: Connector, e: E-ring, h: Holder, s: Screw
Upper cover (h1) (p.5-13) Right nameplate (h2) Maintenance cartridge
Right side cover (s2) (see p.5-14)
Rear right cover (s1,h1) Right cover lid (h2)
2
Spring
Purge unit
Paper release lever
(s4, c2) (see p.5-31)
3
(p.5-18)
Right bottom cover (s2)
(s2,h2) (see p.5-16)
Roll holder slot right (s4)
1
EEPROM cable (c4)
Tube base cover (h4)
Air flow fan (L) (s2,c2)
Cable mount Carriage relay
Tube base (s2)
(s1) PCB (s2)
Feed roller (s2) (see p.5-30)
3 2
5
Cover stay left (s2, c2)
Cover stay right (s2, c3)
Left front cover (s1)
Tensioner
Drive belt
(p.5-19)
Encoder slit (s1) Idler roller mount
(s2)
Feed roller plate (s3)
Belt stopper x2 Spring
Carriage belt Linear scale
Figure 5-7 Disassembly/Assembly Flowcharts for Major Parts
5-8
W6200 W6200
Printer
Rear cover (s12) (p.5-17)
IF cover (s2)
Engine controller
(c16,s6)
Expansion board
System controller (c1,s6)
Upper right cover (s1) (p.5-15)
Right cover (s1,h3) (p.5-15) Carriage home position
sensor (h2)
Front cover Valve motor unit cover (c1,s2)
Paper delivery guide (s2) Valve motor unit (c2,s3)
Air flow fan (R) (s2,c2) Ink tank unit
(c4,s2) (p.5-32)
Suction fan (s2,c2)
Ink tube unit (p.5-20)
Loosen the tensioner on
the idler roller mount
Carriage motor
(s4,c1)
Carriage unit (p.5-25)
Open the upper cover
1
Operation panel
Power supply Platen (L)
(c2,h2)
(c4,s6)
Platen (R)
DC Power supply cable (c6)
Move the carriage over the platen (p.5-36)
Maintenance jet tray Tube holder cover (c1,s2)
(s1)
Tube holder (s1)
5 6
Spring
Printhead lock lever
Head holder (p.5-28)
Sheet
Short flexible
cable (c2)
Head relay PCB
(c4)
5-9
Part 5: Maintenance
Cutter
unit