E0200A/E0200B/E0200C/E0200E/E0200F/E02010/E02017/E02018; Media Sensor Error - Canon W6200 Service Manual

W6200
7.3.3

E0200A/E0200B/E0200C/E0200E/E0200F/E02010/E02017/E02018

Media sensor error

<Cause>
This is displayed when the light intensity of the media sensor could not be adjusted
during media loading.
This is displayed when the media sensor has detected a media loading position error
during detection of the media right edge.
This is displayed when the media sensor could not detect the media leading edge
during detection of the media leading edge.
This is displayed when the media sensor has detected a media smaller than the
prescribed size during media loading.
Media width: Less than 224 mm
Media length: Less than 200 mm
This is displayed when the media sensor has detected a media larger than the
prescribed size during media loading.
Media width: More than 1.4 m
Media length (roll media): More than 15 m
Media length (cut sheet): More than 2.7 m
This is displayed when the media sensor detects slanting that exceeds the prescribed
amount during media loading.
This is displayed when the media sensor could not detect the media right edge
during media loading.
This is displayed when the media sensor could not detect the media left edge during
media loading.
<Probable problem locations>
Media, media loading procedure, paper path, media sensor, carriage relay PCB,
engine controller and system controller
<Remedy>
1.Media check
Replace any media that have printing or soiling at the detection position or that are
outside the prescribed size.
2.Media loading check
Reload the media if there is anything abnormal about the media loading status.
3.Visual check
Remove any foreign objects adhering to the media sensor.
4.Media sensor
Use SERVICE MODE>DISPLAY>SYSTEM>SIZE CR to check the reading of the
media sensor. Replace if it is not functioning normally.
5.Cable connection check
Replace the cable between the media sensor and carriage relay PCB if the
connection is not functioning normally.
6.Replace the carriage relay PCB.
7.Cable connection check
Replace the cable between the carriage relay PCB and engine controller if the
connection is not functioning normally.
8.Replace the engine controller.
9.Replace the system controller.
5-49
Part 5: Maintenance