Idrac Settings Utility - Dell E31S Series Owner's Manual

Option Description
Load Legacy Video Enables you to determine whether the system BIOS loads the legacy video (INT 10H) option ROM from the video
Option ROM controller. Selecting Enabled in the operating system does not support UEFI video output standards. This field is
available only for UEFI boot mode. You cannot set the option to Enabled if UEFI Secure Boot mode is enabled.
In-System Enables or disables In-System Characterization. This option is set to Disabled by default. The two other
Characterization options are Enabled and Enabled - No Reboot.
When enabled, In-System Characterization (ISC) executes during POST upon detecting relevant change(s) in
system configuration to optimize system power and performance. ISC takes about 20 seconds to execute, and
system reset is needed for ISC results to be applied. The Enabled - No Reboot option executes ISC and
continues without applying ISC results until the next time system reset occurs. The Enabled option executes ISC
and forces an immediate system reset so that ISC results can be applied. It takes the system longer to be ready
due to the forced system reset. When disabled, ISC does not execute.
Related tasks
Viewing Miscellaneous Settings
Related reference
Miscellaneous Settings

iDRAC Settings utility

The iDRAC settings utility is an interface to set up and configure the iDRAC parameters by using UEFI. You can enable or disable various
iDRAC parameters by using the iDRAC settings utility.
NOTE: Accessing some of the features on the iDRAC settings utility needs the iDRAC Enterprise License upgrade.
For more information about using iDRAC, see Dell Integrated Dell Remote Access Controller User's Guide at Dell.com/idracmanuals.
Related concepts
Device Settings
Related tasks
Entering the iDRAC Settings utility
Changing the thermal settings
Related reference
System BIOS
Entering the iDRAC Settings utility
Steps
1. Turn on or restart the managed system.
2. Press F2 during Power-on Self-test (POST).
3. On the System Setup Main Menu page, click iDRAC Settings.
The iDRAC Settings screen is displayed.
Related reference
iDRAC Settings utility
Changing the thermal settings
The iDRAC settings utility enables you to select and customize the thermal control settings for your system.
NOTE: The default setting for In-System Characterization is subject to change in future BIOS
releases.
Pre-operating system management applications 51