Figure 2-22 Typical 2-Carrier System 75 Cabinet Or 2-Cabinet System 75 Xe Floor Plan - AT&T 75 Wiring Manual

NOTES:
1. THE POWER OUTLET MUST NOT BE UNDER SWITCH CONTROL AND MUST NOT BE SHARED WITH OTHER
EQUIPMENT. THE POWER OUTLET SHOULD BE LOCATED OUTSIDE THE CROSS-CONNECT FIELD AREA.
ALSO, ANY CONDUIT SERVING THE OUTLET CANNOT RUN THROUGH OR BELOW THE AREA WHERE THE
CONNECTOR MODULES ARE TO BE MOUNTED.
2. ALLOW AT LEAST 36 INCHES (91.4 cm) OF SPACE IN FRONT AND 6 INCHES (15.4 cm) ON THE
RIGHT OF THE CABINET TO PERMIT THE DOOR TO SWING OPEN.
3. CABINET IS LOCATED ALONGSIDE THE CROSS-CONNECT FIELD WHEN CABLE SLACK MANAGER IS NOT
USED.
Figure 2-22. Typical 2-Carrier System 75 Cabinet or 2-Cabinet System 75 XE
Floor Plan
Z100-TYPE HARDWARE
2-31