Installing Z100-Type Hardware At Satellite Locations - AT&T 75 Wiring Manual
Hide thumbs
Also See for 75:
- Wiring diagram (345 pages) ,
- User manual (103 pages) ,
- User manual (45 pages)
Table of Contents
Advertisement
Z100-TYPE HARDWARE
Installing Z100-Type Hardware at Satellite Locations
To install the Z100A1 connector modules at the satellite location, use the same installation
procedure described under the heading Installing the Cross-Connect Field. Figure 2-65
shows a typical satellite location installation.
NOTES:
2. THIS DISTANCE IS FROM THE FLOOR TO
Figure 2-65. Typical Satellite Installation
As shown in Figure 2-66, 3-pair station circuits connect to the bottom three connecting units
(white field). Four-pair station circuits connect to the top four connecting units (blue field).
2 - 9 2
1. EACH CONNECTOR MODULE AND THE Z9A
SUPPORT IS 5 INCHES (12.7 CM) WIDE.
THE BOTTOM OF THE Z9A SUPPORT
Advertisement
Chapters
Table of Contents
