Installing Selector Console - AT&T 75 Wiring Manual

Installing Selector Console

Requirements
The selector console is connected to the attendant console by a 3-foot (91-cm) D8AC cord
provided with the selector console (see Figure 2-80).
Installation
1 . Run and connect 3-foot (91-cm) D8AC cord between DXS/BLF jack on bottom of
attendant console and modular jack on bottom of selector console.
Note: These jacks are located on the bottom of the consoles.
2 .
Install labels per Attendant Console Form.
Administer per AT&T System 75 and System 75 XE Implementation and A T & T
3 .
System 75 and System 75 XE Administration.
Figure 2-80. Selector Console Installation
Z100-TYPE HARDWARE
2-111