Installing 66-Type Hardware At Satellite Locations; Labeling; Installing 4-Pair Station Cables; Installing The Information Outlets - AT&T 75 Wiring Manual

66-TYPE HARDWARE

Installing 66-Type Hardware at Satellite Locations

To install the 66-type connecting blocks at the satellite location, use the same installation
procedure described under the heading Installing the Cross-Connect Field. Figure 4-46
shows a typical satellite location layout.
Figure 4-46. Typical Satellite Location Layout
Three-pair station circuits are run from the equipment room to the satellite closet white
field and four-pair station circuits are run from the satellite closet blue field to the
information outlets. Connections to both the three- and four-pair circuits can be made with
connectorized or field-terminated cables depending on the type of connecting blocks used.

Labeling

Figure 4-46 shows the fill directions for the blue and white fields at the satellite location.
The labeling for the lead designations is written on the connecting blocks using a permanent
felt-tipped pen as described under Labeling the Cross-Connect Field.

Installing 4-Pair Station Cables

The 4-pair station cables can either be plugged into the adapters or field-terminated at the
cross-connect field or satellite closet and run to the information outlet locations.

Installing the Information Outlets

Install the information outlets (Figure 4-47) at the terminal locations. See Table 4-I for
wiring information.
4 - 7 4