To Adjust The Copy Image Quality In The Full Color Mode - Toshiba e-Studio6506AC Imaging Manual

2. Copier-specific Adjustments

2.1.2 To Adjust the Copy Image Quality in the Full Color Mode

* The setting value for the Full color mode shall be applied also when the original is judged as the full color
image in the Auto color mode.
* You can start with any of the procedures. But it is recommended to perform the procedures in order, as listed
below. You can use one procedure in conjunction with another. But if this changes the image quality more than
required or loses the effectiveness of the adjustment, restore the settings made in the previously used procedure
to the original ones. Then use other procedures.
* Both the service technician and the user can use procedures (1), (3) and (7).
* Only the service technician must use procedures (2), (4), (5), (6), (8) and (9).
(1) Press [BASIC] on the Control Panel. Press [
After increasing the copy density, copy and check the copy image quality.
With the copy density set to the maximum, if further image quality adjustments are still necessary, the
service technician must use the following procedures
(2) Select [05 ADJUSTMENT MODE]. Increase the values for codes [7713 to 7726] to strengthen the copy
density of text.
• The code to be set varies depending on the original mode setting (Text/photo, Text, Printed image, Photo
(developing paper), Map, User custom, Red seal color) or the manual/automatic density setting. Select the
[05] code for the mode in which the image quality is to be changed, and set "128" or more for the setting
value.
Color
Target
mode
Manual
density
Full color
Automatic
density
* When the manual setting value of the manual density is altered while it is set in the BASIC menu on the
control panel, the density in the steps in all the indicators including the center value is also changed. One
step in the indicator corresponds to "20" of the setting value in [05] code.
e-STUDIO5506AC/6506AC/7506AC (Ver01)
] to increase the copy density.
Original mode [05]code
Text/Photo 05-7713
Text 05-7714
Printed image 05-7715
Photo 05-7716
Map 05-7717
User custom 05-7718
Red seal color 05-7719
Text/Photo 05-7720
Text 05-7721
Printed image 05-7722
Photo 05-7723
Map 05-7724
User custom 05-7725
Red seal color 05-7726
Recommended
value
Set a value larger
than 128.
Set a value larger
than 128.
© 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
2-6
Acceptable
Default
value range
0 to 255 128
0 to 255 128