Toshiba e-Studio6506AC Imaging Manual page 61

(5) Select [05 ADJUSTMENT MODE]. Change the values for codes [7960 to 7987] to adjust the color density.
Color to
Original mode [05] code Subcode
adjust
Text/Photo
Text
Printed image
Y
Photo
(Yellow)
Map
User custom
Red seal color
Text/Photo
Text
Printed image
M
Photo
(Magenta)
Map
User custom
Red seal color
Text/Photo
Text
Printed image
C
Photo
(Cyan)
Map
User custom
Red seal color
Text/Photo
Text
Printed image
K
Photo
(Black)
Map
User custom
Red seal color
* Set the value in increments of approximately 10, while checking the copy image until the optimum value is
obtained.
* The value for the code corresponding to the original mode (Text/Photo, Text, or Printed image) will affect
the copy image quality in the Full color mode and the Auto color mode.
* The subcode varies according to the area where the density is adjusted. Refer to the table below and set the
subcode for the area to be adjusted.
Subcode
0
1
2
 Caution after the adjustment
The adjustment may possibly cause offset failure, particularly when the highly colored original is copied in the
Photo mode. Therefore, carefully perform the adjustment, while checking the copy image.
 Remarks
Enter a value within the recommended value range mentioned in the procedures. Otherwise, it may cause a loss in
MFP performance, including degradation in the image quality and a reduction in the life of the consumables.
e-STUDIO5506AC/6506AC/7506AC (Ver01)
05-7960 0/1/2
05-7961 0/1/2
05-7962 0/1/2
05-7963 0/1/2
05-7964 0/1/2
05-7980 0/1/2
05-7984 0/1/2
05-7965 0/1/2
05-7966 0/1/2
05-7967 0/1/2
05-7968 0/1/2
05-7969 0/1/2
05-7981 0/1/2
05-7985 0/1/2
05-7970 0/1/2
05-7971 0/1/2
05-7972 0/1/2
05-7973 0/1/2
05-7974 0/1/2
05-7982 0/1/2
05-7986 0/1/2
05-7975 0/1/2
05-7976 0/1/2
05-7977 0/1/2
05-7978 0/1/2
05-7979 0/1/2
05-7983 0/1/2
05-7987 0/1/2
Area where the density is adjusted
Low-density area
Medium-density area
High-density area
2. Copier-specific Adjustments
Recommended value
Set a value larger than 128
to increase the density.
Set a value smaller than 128
to decrease the density.
© 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
2-15
Acceptable
Default
value range
0 to 255 128