Toshiba e-Studio6506AC Imaging Manual page 24

1. General Adjustments – Copying, Printing and e-Filing (Output from Box)
Code setting values
Value
0
1
2
3
4
5
6
7
8
9
10
* Decreasing the value will make the solid colored area become lighter (decrease the amount of toner
on the solid colored area). On the other hand, increasing the value will make the solid colored area
become darker (increase the amount of toner on the area).
(b) Select [05 ADJUSTMENT MODE], select code [2742], and then press the [START] button.
After the image quality control is finished, perform printing to check the image quality of the solid
colored area.
* The changed setting values for 08-2513/2514 will be effective for the image printed immediately
after the change. When these values are changed, performing image quality control with 05-2742 is
recommended.
Repeat procedures (a) to (b) as required in order to change the setting value so that the solid colored area
becomes your desired density.
Since the density of a gradation area (halftone), such as a photograph, is adjusted as well as that of a solid
colored image, follow the procedure below.
 Caution after the adjustment
• The adjustment may possibly cause extremely dark images (decreased resolving power and lack of gradation
reproducibility) and extremely light images (blurred images and faint thin lines). Therefore, perform adjustment
carefully while checking the copy or print image.
• Depending on the installation environment of the MFP, the effects of adjustment may not appear. Therefore,
perform adjustment carefully while checking the copy or print image.
 Remarks
• The effects of adjustment may vary, depending on the usage pattern of the consumables, such as the developer
material and drum, and the installation environment of the MFP.
• When replacing any consumables, refer to the relevant information in the Service Manual.
e-STUDIO5506AC/6506AC/7506AC (Ver01)
Correction value for developer bias
output
Value automatically set −100
Value automatically set −80
Value automatically set −60
Value automatically set −40
Value automatically set −20
Value automatically set
Value automatically set +20
Value automatically set +40
Value automatically set +60
Value automatically set +80
Value automatically set +100
1 - 8
Density of the solid colored
Default
© 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
area
Light
↑
↑
↑
↑
↓
↓
↓
↓
Dark