To Adjust The Copy Image Quality Of A Black Logo - Toshiba e-Studio6506AC Imaging Manual

2. Copier-specific Adjustments

2.11.1 To Adjust the Copy Image Quality of a Black Logo

* You can start with any of the procedures. But it is recommended to perform the procedures in order, as listed
below. You can use one procedure in conjunction with another. But if this changes the image quality more than
required or loses the effectiveness of the adjustment, restore the settings made in the previously used procedure
to the original ones. Then use other procedures.
* Both the service technician and the user can use steps (1) and (2).
* Only the service technician can use steps (3) and (4).
<Important> Before you start this adjustment, make sure that no color misalignment exists on the logos.
If there is any, correct it before adjustment. For how to correct the color misalignment
(deviation), refer to "1.5 To Correct Out-of-Registration Colors" in this manual and also the
Service Manual.
(1) Press [BASIC] on the Control Panel. If you want to emphasize the reproducibility of text more, select
"TEXT" as an original mode. If you want to emphasize that of photos, select "TEXT/PHOTO".
* If you want the "TEXT" or "TEXT/PHOTO" mode to be the default original mode, refer to "2.18 To
Program Frequently Used Copy Settings (To Use Custom Mode)".
After selecting the Text mode, copy and check the copy image quality.
If further image quality adjustment is necessary, go to the next step.
(2) Perform color balance adjustment to enhance black.
• Use steps (a) through (d) to perform the adjustment.
(a) Press [IMAGE] on the Control Panel.
(b) Press [COLOR BALANCE].
(c) Press [+] to enhance the tint of [BLACK].
* Press [DETAIL]. The tint of the color can be adjusted according to the density area (low-, medium-
or high-density area).
(d) Press [ENTER].
After adjusting the tint of black, copy and check the copy image quality.
If further image quality adjustment is necessary even after the tint of black was set to the maximum, the
service technician must perform the next step.
e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
2-52