When Adjusting The Image Quality Of The Full Color Mode - Toshiba e-Studio6506AC Imaging Manual

(2) Enter [05 ADJUSTMENT MODE] and change the setting values for the codes from [7150] to [7152] to
adjust the noise reduction level.
Original
Color mode
mode
Text/Photo
Black
Text
User custom
* The smaller the value is, the larger the noise reduction level becomes. The larger the value is, the smaller
the noise reduction level becomes.
* When "0" is set for the setting value, this function becomes disabled.
After changing the setting value, perform printing and check its image quality.
 Caution after the adjustment
Nothing in particular

2.23.2 When adjusting the image quality of the Full color mode

* Both the service technician and the user can use all steps of this adjustment.
<Notes>
・This adjustment is available when the Text/Photo mode is selected for the original mode for full color copying.
・Normally, the use with the factory default setting (Disabled) is recommended since the adjustment may
decrease the reproducibility of fine characters.
(1) Press [Image] and then [ADF Noise Reduction] on the control panel.
Change the setting value of the noise reduction level.
Setting value
None
Low
Middle
High
After changing the setting value, perform printing and check its image quality.
 Caution after the adjustment
Nothing in particular
e-STUDIO5506AC/6506AC/7506AC (Ver01)
[05] Code Recommended value
7151
Set a value smaller than
7152
7150
Description
The noise reduction function is disabled.
The noise reduction level is low.
The noise reduction level is medium.
The noise reduction level is high.
© 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
2-85
2. Copier-specific Adjustments
Acceptable
value range
0 to 200
100.
Default
100