Toshiba e-Studio6506AC Imaging Manual page 108

2. Copier-specific Adjustments
* The table below shows you the acceptable paper weight for the paper type.
Paper type
Thick 1
Thick 2
Thick 3
Thick 4
* Use the recommended OHP transparencies and special paper-1 and -2.
After adjusting the amount of toner used, copy and check the copy image quality.
If further image quality adjustments are still necessary, the service technician must use the next procedure.
(3) Perform color balance adjustment or RGB adjustment to adjust the tint of the colors in general.
* For further information regarding the adjustment procedures, refer to procedure (3) in 2.2 To Closely
Match the Color Balance of the Original.
After adjusting the tint of colors, copy and check the copy image quality.
If further image quality adjustments are still necessary, use the next procedure.
(4) Select [05 ADJUSTMENT MODE]. Change the values for codes [7960] to [7987] to adjust the density level
of each color.
Color to
Original mode [05] code Subcode
adjust
Text/Photo
Text
Printed image
Y
Photo
(Yellow)
Map
User custom
Red seal color
Text/Photo
Text
Printed image
M
Photo
(Magenta)
Map
User custom
Red seal color
Text/Photo
Text
Printed image
C
Photo
(Cyan)
Map
User custom
Red seal color
Text/Photo
Text
Printed image
K
Photo
(Black)
Map
User custom
Red seal color
e-STUDIO5506AC/6506AC/7506AC (Ver01)
Acceptable paper weight
106 to 163 g/m²
164 to 209 g/m²
210 to 256 g/m²
257 to 280 g/m²
05-7960 0/1/2
05-7961 0/1/2
05-7962 0/1/2
05-7963 0/1/2
05-7964 0/1/2
05-7980 0/1/2
05-7984 0/1/2
05-7965 0/1/2
05-7966 0/1/2
05-7967 0/1/2
05-7968 0/1/2
05-7969 0/1/2
Set a value larger than 128
05-7981 0/1/2
to increase the density.
05-7985 0/1/2
05-7970 0/1/2
Set a value smaller than 128
05-7971 0/1/2
to decrease the density.
05-7972 0/1/2
05-7973 0/1/2
05-7974 0/1/2
05-7982 0/1/2
05-7986 0/1/2
05-7975 0/1/2
05-7976 0/1/2
05-7977 0/1/2
05-7978 0/1/2
05-7979 0/1/2
05-7983 0/1/2
05-7987 0/1/2
2-62
Max. 60 lb. Cover
Max. 110 lb. Index
Max. 140 lb. Index
Max. 100 lb. Cover
Recommended value
© 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
Acceptable
Default
value range
0 to 255 128