Toshiba e-Studio6506AC Imaging Manual page 101

(4) Select [05 ADJUSTMENT MODE]. Change the setting values for codes [7960], [7961], [7965], [7966],
[7970], [7971], [7975], [7976] and [7980] to [7983] to adjust the density for each color.
Color to
Original mode
adjust
Text/Photo
Y
Text
(Yellow)
User custom
Red seal color
Text/Photo
M Text
(Magenta)
User custom
Red seal color
Text/Photo
C Text
(Cyan)
User custom
Red seal color
Text/Photo
K
Text
(Black)
User custom
* Set the value in increments of approximately 10, while checking the copy image until the optimum value is
obtained.
* The subcode varies according to the area where the density is adjusted. Refer to the table below and set the
subcode for the area to be adjusted.
Subcode
0
1
2
 Caution after the adjustment
The adjustment may possibly cause a dark-colored area, such as in a photo, to become blurred on the copy. Also,
it may also cause offset failure, grained images and degradation in gradation. Therefore, carefully perform the
adjustment, while checking the copy image.
e-STUDIO5506AC/6506AC/7506AC (Ver01)
[05] code
05-7960
05-7961
05-7980
05-7984
05-7965
05-7966
05-7981
05-7985
05-7970
05-7971
05-7982
05-7986
05-7975
05-7976
05-7983
Area where the density is adjusted
Low-density area
Medium-density area
High-density area
2. Copier-specific Adjustments
Recommended
Subcode
value
0/1/2
0/1/2
0/1/2
0/1/2
0/1/2
0/1/2
0/1/2
Set a value larger than
0/1/2
128.
0/1/2
0/1/2
0/1/2
0/1/2
0/1/2
0/1/2
0/1/2
© 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
2-55
Accep
table
Default
value
range
0 to
128
255