Zoneflex 7372 - Ruckus Wireless ZoneFlex series User Manual

Figure 8: 7352/7372 rear panel
Table 6: 7352/7372 rear panel elements
Item Name
10/100/1000+PoE Port
10/100 Port
Power
RST Button

ZoneFlex 7372

The ZoneFlex 7372 is a best-performing, concurrent dual-band, mobile-ready, two-stream
802.11n AP.
NOTE The 100.x AP base images support standalone mode and FlexMaster (FM)
WLAN manager operation. The SmartZone software-compatible images only support
SCG, SZ and vSZ controllers. The ZD-compatible images only support ZD controllers.
NOTE The 7372 requires a minimum of AP base image 100.0.0 and later to operate,
or SCG 1.1.1 and later, vSZ 2.5 and later, SmartZone software 3.2 and later, or ZD 9.5.1
and later to operate.
The 7372 includes five LEDs on its front panel and buttons and connectors on its rear
panel.
Front Panel
The following figure shows the top view of the 7372. For a description of each front panel
part, refer to the table below.
ZoneFlex Indoor Access Point Release 104.0 User Guide
Getting to Know the AP Features
Description
One RJ-45 port for a 10/100/1000 PoE
(Power over Ethernet, 802.3af) connection.
One RJ-45 port for a 10/100 connection.
Connect the power adapter (12
VDC/1.25A) to this socket. Power can also
be supplied via the 10/100/1000 PoE port.
Pressing, and then quickly releasing this
internal button reboots the AP. Pressing
and holding it for six seconds resets the
AP to factory default settings.
CAUTION! Resetting the AP to factory
default settings erases all previously
configured settings.
Introduction
21