Rebooting The Ap - Ruckus Wireless ZoneFlex series User Manual

Administration

Rebooting the AP

• Click Perform Upgrade, which starts the process and the clock. The next upgrade
occurs at the selected interval.
• Click Save parameters only. The clock starts right away, and the actual upgrade
occurs at the first selected interval.
After you click one of these two options, a status bar appears during the upgrade
process.
When the upgrade is complete, the AP automatically reboots at the time you specified
in Step 5.
Rebooting the AP
You can use the web interface to prompt the AP to reboot, which simply restarts the
AP without changing any of the current settings.
Please note that rebooting the AP disrupts network communications in any currently
active WLANs.
1. Go to Maintenance > Reboot/Reset. The Maintenance > Reboot/Reset page
appears.
2. Click Reboot Now. After a brief pause, you are automatically logged out of the AP.
Figure 76: The Maintenance > Reboot/Reset page
After approximately one minute, you should be able to log back into the AP, which verifies
that the reboot was successful. You can also check the LEDs on the AP to verify the
status of the device.
144 ZoneFlex Indoor Access Point Release 104.0 User Guide