Viewing Associated Wireless Clients - Ruckus Wireless ZoneFlex series User Manual

Administration

Viewing Associated Wireless Clients

Setting
AeroScout Engine communication daemon
(some APs)
Ekahau Engine communication daemon
(some APs)
ERC IP (some APs)
ERC Port (some APs)
If you want to make changes to any of these settings, go to the Configuration > Wireless
page. Refer to Configuring Common Wireless Settings
Viewing Associated Wireless Clients
The Status > Wireless page provides an overview of currently connected wireless clients.
A usage-monitoring capability has been built into the AP to help you monitor wireless
clients that are associated with your wireless network.
1. Go to Status > Wireless. The Status > Wireless page appears.
NOTE If you are using a dual-band AP, then go to Status > Radio 2.4G or Status
> Radio 5G.
2. Click any of the Wireless # tabs. Wireless clients that are associated with this
particular wireless network appear under Connected Devices.
132
Description
Shows Up if the communication agent on
the AP is able to relay location data from
AeroScout Tags to the AeroScout Engine.
If the communication agent is unable to
relay data or AeroScout tag detection is
disabled, this field shows Down.
Shows Enabled if you have enabled Ekahau
RFID tag detection. Default is disabled.
Ekahau Real Time Location System RTLS
Controller IP address.
TCP port used by the Ekahau Real Time
Location System RTLS Controller.
on page 99 for more information.
ZoneFlex Indoor Access Point Release 104.0 User Guide