Step 1: Preconfiguring The Ap - Ruckus Wireless ZoneFlex series User Manual

Installation

Step 1: Preconfiguring the AP

Figure 38: Recommended wall mounting orientation
Figure 39: Recommended wall mounting in a corridor (top view)
Step 1: Preconfiguring the AP
Preconfigure the AP for standalone operation, for management by FlexMaster, or for
management by a Ruckus Wireless ZoneDirector or SmartZone controller.
NOTE The 100.0.0 and later APs are shipped from the factory with an AP base image,
which supports standalone and FlexMaster-managed operation, and which does not
support SmartZone or ZoneDirector controller operation. After you have configured the
AP with the base image as described in the following sections, the AP automatically
goes out and finds any operator-defined controllers. If the AP finds a controller that is
configured to automatically recognize the AP, then the controller downloads the
74 ZoneFlex Indoor Access Point Release 104.0 User Guide