Cooper Security i-on40 Programming Reference Manual page 86

Installer Mode Programming
Phone Book
(This option appears only when the i-sd02, i-dig02 or i-
gsm02 module is fitted.)
Select Downloading - Phone Book to program two separate,
31-digit telephone numbers that the system will use
during downloading. When the remote PC operator makes
a connection they select one of these telephone numbers
for the control unit to call back on (for example to the
operator's home or office).
Press u or n keys to move the cursor backwards and
forwards through the number if you wish to edit it.
Press < to delete the digit to right of the cursor.
Press * to add a 2 second pause, if required. The display
shows this as a comma.
IP Network
If you have fitted an Ethernet module (08750EUR-00) to
the control unit then it is possible for Downloader to
communicate with the control unit using the Internet
Protocol. This menu allows you to store two IP addresses
that the control unit can "call" in order to start a
Downloading session. The user starts the call by selecting
one of the IP address.
The options available are:
IP Address
This option presents two sub-menus where you can
key primary and secondary IP Addresses used by
Downloader. The IP address comprises four groups of
digits. Each group is three digits long, and is
separated from the next group by a "dot", for
example "192.168.000.001". Press "*" to key in the
dot.
IP Port Number
This option also presents another two sub-options
where you can key in the port numbers that
Downloader "listens" to on the remote PC for the
primary and secondary IP addresses.
Page 82
i-on40