Important! Saving Changes To The Installer Menu; Restoring Access Codes - Cooper Security i-on40 Programming Reference Manual

i-on40
Press X to return to the Installer Menu. You must
rectify the fault (or delete the device from the
system) before you can leave the Installer Menu.
Important!
Saving Changes to the Installer Menu
When you make changes to the Installer Menu the control
unit holds those changes in temporary memory until you
leave the Installer Menu. As you leave the Installer Menu
the control unit writes those changes into a permanent
store. If you remove all power BEFORE you leave the
Installer Menu then the control unit will lose your
changes. Note that this does not apply if you restore
Factory Defaults, that change takes place immediately.

Restoring Access Codes

If the User and/or Installer codes are lost then:
1. If possible, enter the Installer menu.
Note: If you cannot enter Installer Menu then the control
unit will start a tamper alarm when you open its lid.
2. Remove mains power, then open the control unit and
disconnect the battery .
Note: This procedure will not work if the control unit lid
tamper remains closed.
3. Identify the Reset Codes pins on the main PCB (see i-
on40 Installation Guide).
4. Short the Reset pins together using a small
screwdriver or jumper link. (Keep the short on until
step 6.)
5. Apply mains power.
The control unit loads the factory default access
codes:
User 1: 1234, Installer: 7890.
After a short pause the keypad display shows the
time and date. The red LEDs glow to show an alert
that the control unit lid is open.
The sounders operate.
Entering and Leaving Installer Menu
Page 5