Restoring Factory Defaults Only - Cooper Security i-on40 Programming Reference Manual

Entering and Leaving Installer Menu
6. Remove the short from the Reset pins.
7. Reconnect the battery.
8. Close the control unit lid (to restore the tamper
switch).
9. Key in the Master User code 1234 to silence the
sirens.
Press Y twice (if necessary) to acknowledge any
alerts. To force the control unit to check the battery:
10. Enter installer menu and then leave it again.
The navigation key LEDs should now glow green.

Restoring Factory Defaults Only

If you wish to restore all factory default options, then:
1. From the Installer Menu select System Options –
Restore Defaults – Factory Defaults.
The display asks for confirmation.
2. Press Y to load defaults.
(Press X to go back to the Installer Menu without
changing defaults.)
The display asks you to select Partition Mode or Part
Set Mode.
3. Press A or B to select the desired mode.
The display asks you to select the zone wiring type.
4. Press u or n to display the desired wiring type on
the bottom line of the display and then press Y to
select it.
The system loads all defaults except for Access Codes
and the Log (see Note).
The display shows "
5. Leave the Installer Menu to save the change (press X
until the display shows "
press Y.
Note: The log is protected and cannot be erased by the
Installer or any user.
Page 6
Factory defaults restored
Leave Installer Menu ?
i-on40
".
" then