Advertisement
Advertisement
Table of Contents
Related Manuals for Cooper Security I-SD01
Summary of Contents for Cooper Security I-SD01
- Page 1 I-SD01 Speech Dialler Installation and Programming Guide...
- Page 2 Introduction The I-SD01 module is designed to fit on the I-ON16 control unit. The I-SD01 allows the control unit to report alarm conditions over the public switched telephone network (PSTN) using either recorded speech messages, or SMS (Short Message Service) texts to mobile telephones by way of the PSTN.
- Page 3 1. Remove mains power from the end station. 2. Open the end station lid and disconnect the battery. 3. Fit the I-SD01 to the plug on module sockets (see Figure 2). Figure 2. Fitting I-SD01 Module 4. Connect the module to the PSTN.
-
Page 4: Finishing The Installation
Every effort has been made to ensure that the contents of this book are correct. However, neither the authors nor Cooper Security Limited accept any liability for loss or damage caused or alleged to be caused directly or indirectly by this book. The contents of this book are subject to change without notice.
Need help?
Do you have a question about the I-SD01 and is the answer not in the manual?
Questions and answers