Cooper Security i-on40 Programming Reference Manual page 76

Installer Mode Programming i-on40
number in this slot at will. This allows the user to re-
direct any speech message destined for this number. The
user cannot disable the telephone number by entering a
blank number; the fact that they have changed the
number is logged.
Triggers
In the i-on40 you can link up to five different trigger
events to each speech message. A trigger event is one
item selected from a list of alarm types.
To link specific trigger events to individual messages
select Communications – Speech Dialler – Triggers.
The display shows a list of speech messages. (Note that
the home message does not appear. The control unit
always sends the home message at the beginning of each
transmission.) Select the message that you wish to
program. The display then shows a list of five triggers.
Select a trigger and the display shows a list of available
alarm events. Select one alarm event for that trigger.
When you have selected an alarm event the display
shows the list of triggers again. You may program one
alarm event for each of the five triggers in the list.
When you finish selecting alarms for each trigger, you
have now linked alarm events to triggers, and one or
more triggers to a message.
Destinations
Once you have programmed telephone numbers,
messages and triggers, you must then link specific
messages to individual telephone numbers. To do this
select Communications – Speech Dialler – Destinations.
Select a message from the list on the display. The control
unit will show you a list of telephone numbers. If you
gave a telephone number a name then the display shows
the name instead of the digits of the number.
Highlight a telephone number and press > until a "Yes"
appears after the number. Press Y when you have
finished. The control unit will send the selected speech
message to every telephone number with a "Yes" next to
it.
Page 72