Entering And Leaving Installer Menu; Entering The Installer Menu - Cooper Security i-on40 Programming Reference Manual

i-on40

Entering and Leaving Installer Menu

Entering the Installer Menu

1. Make sure the system is unset
and showing the standby screen
(time and date).
2. Key in the Installer access code.
When delivered from the factory
the default Installer access code
is "7890". The default user code
is "1234".
As you start to key in the code
the display shows:
When you key in the last digit of
the access code the display MAY
show:
If this happens key in a valid
user code (not a Set Only user
code see note 1).
When you key in the last digit of
the access code the display
shows "Installer Menu" on the
top line. The bottom line shows
the first item in the Installer
menu: Detectors/Devices. (See
note 2.)
3. Press u or n to display more
options from the menu.
Each option appears on the
bottom line of the display in turn.
4. Press > or Y to select that item
of the menu.
The option you selected now
appears on the top line. If there
are any sub-options for that
selection, then the first of them
i-on40
12:00 23/07/2009
Enter Access Code:
(* )
User Code Required
( )
INSTALLER MENU
Detectors/Devices >
INSTALLER MENU
Outputs
OUTPUTS
Edit Outputs
Page 3
>
>