Sms - Cooper Security i-on40 Programming Reference Manual

i-on40
Note: There are a total of five voice messages available.
The control unit always sends the Home Message at
the beginning of every speech report. The control
unit then sends messages 1, 2, 3 or 4 to the
telephone numbers you selected.
Call Acknowledge
If the called party answers a speech dialler call, then they
can end the call by sending back a DTMF '5'.
With Call Acknowledge enabled the control unit ends the
call when it receives a DTMF '5' or '9'. If the control unit
does not receive a DTMF '5' or '9' then it attempts to call
again (up to three times).
With Call Acknowledge disabled the control unit stops
further call attempts to that number as soon as it detects
a call being answered.
Note that after receiving a DTMF '5' the control unit will
go on to call any other programmed speech dialler
numbers.
After receiving a DTMF '9' the control unit will cancel all
further calls for the current alarm.

SMS

The control unit can send alarm reports by SMS message
to any of four telephone numbers. Each alarm report is a
single SMS message, comprising:
A Home Message and a text message. You must
program the control unit with the content of these
messages.
The text of the log entry that corresponds to the event
causing the alarm.
The time and date of the alarm.
The zone name of the zone causing the alarm.
Installer Mode Programming
Page 73