Sc200 Or Sc100 Operation Using A Pc/Laptop; Using Dctools Via Usb (Sc200 Only) - Eaton RM3-400-0330 Installation And Operation Manual

RM3-400/410/420 Series Installation and Operation Guide
Audible indicator
One beep – indicates an invalid key press
•
Three beeps every 2 seconds – refer to the alert message on the display (SC200 only)
•
One beep every 2 seconds – Minor alarm is active
•
Continuous sound – Critical/Major alarm is active
•
► To stop the audible indicator
Press any key
•
► To enable/disable the audible alarm indicator
Either:
On SC200 go to: Alarms > Alarm Settings > Audible Alarms > Edit.
•
or on SC100 go to: Menu > Configuration > Audible Alarm.
•
Or:
In DCTools/Web go to: Alarms > Alarm Configuration.
•
When Disabled, the audible indicator will still indicate an invalid key press.

SC200 or SC100 Operation Using a PC/Laptop

DCTools is configuration software for editing a system controller's configuration file (on-line)
and monitoring the operation of Eaton's dc power systems. It is available free from
www.powerquality.eaton.com/downloads.

Using DCTools via USB (SC200 only)

DCTools can be run on a PC/laptop connected to the SC200's USB port.
DCTools can also be run on a remote PC/laptop connected to the SC200's RS232 serial port (via a
modem) or Ethernet port. For remote PC/laptop connection details see Communications Options
in the System Controller Operation Handbook.
Before you start you will need:
The latest version of DCTools available from www.powerquality.eaton.com/downloads.
•
A PC/laptop with USB port and USB A/B cable (RadioShack 55010997, Jaycar WC7700, or
•
equivalent).
► To connect a PC/laptop to the SC200:
Download the latest version of DCTools from www.powerquality.eaton.com/downloads.
1
Install DCTools on the PC/laptop.
2
38
Critical/Major alarms always override Minor alarms.
The audible indicator will restart at the next active alarm or alert message.
Copyright © 2007-2010 Eaton Corporation. All Rights Reserved.
IPN 997-00012-62E June 2010