Starting The Sc200 Or Sc100; Sc200 - Eaton RM3-400-0330 Installation And Operation Manual

► To use a web browser for Restore (SC200 only)
Connect to the SC200 via a web browser. For details see Ethernet Communications in the
1
System Controller Operation Handbook.
Go to Tools.
2
Select Restore Tool.
3
Select the file type:
4
System Snapshot (*.dcs): Configuration file including site specific settings.
•
Configuration (*.dcc): Configuration file without site specific settings - Site Identity, IP
•
Address, S3P Address, battery characterization data).
Fragment (*.dcf): Restore part of a configuration file (such as battery characterization
•
data).
Click Next, and then select a file name to Restore a configuration.
5

Starting the SC200 or SC100

When dc power is applied to the SC200 or SC100 (via the RXP connector YS11) the start-up
sequence begins.

SC200

Start-up screen
Approx.
120s
Main screen
The values shown are
configurable, see details in
the System Controller
Operation Handbook. All
active Critical, Major,
Minor and Warning alarms
are displayed.
Copyright © 2007-2010 Eaton Corporation. All Rights Reserved.
IPN 997-00012-62E
Menu screen
See navigation details on page
If Logon is required see
Keypad Access Security on
June 2010
System Controller
61.
page 36.
35