Task 5 - Connect Optional External I/O Module (Some Models Only) - Eaton RM3-400-0330 Installation And Operation Manual

Task 5 - Connect Optional External I/O Module (some models only)

Optional SiteSure-3G input/output modules can be connected to models with an SC200 system
controller (see Model Numbers on page 2). A SiteSure-3G input/output module has the
following features.
Digital Inputs
Digital Outputs (relays)
Analog Inputs (-10V to +10V)
Current Sense Inputs
Temperature Sense Inputs
Bus Voltage Input (0-60V)
Enclosure
Use the following procedure to connect a SiteSure-3G input/output module, if required.
Step 1 - Remove the top cover
Step 2 - Terminate the cabling
1
2
3
4
5
6
Step 3 - Replace the top cover
Procedure complete
For details on setup refer to the SiteSure-3G Installation Guide. See Related Information on page
i.
Wall or panel mounting plastic case
Route CAT 3 patch cable (4 pair, 26AWG, UTP, 75°C) from the SiteSure-3G
module to the rear of the dc power system.
Terminate the cable with RJ45 plugs.
Test the insulation and continuity of the conductors.
Connect the cable to a spare RJ45 socket (S1 or S2) on the Voltage Feed Module
board. See the diagram on page
If there is no spare socket or additional SiteSure-3G input/output modules are to be
connected then use an RJ45 splitter.
Use cable ties to secure the cable and prevent strain on the connectors.
Connect the cable to socket YH11 on the SiteSure-3G module.
Copyright © 2007-2010 Eaton Corporation. All Rights Reserved.
IPN 997-00012-62E
SiteSure-3G
10
6
4
3
2
1
3 for location.
June 2010
Installation
21