Task 5 - Applying Power To The Dc-Powered Equipment; Start-Up Completed - Eaton RM3-400-0330 Installation And Operation Manual

Task 5 - Applying Power to the dc-powered Equipment

Reverse Polarity
•
Always check that the dc cables have been terminated to the correct system polarity BEFORE connecting
dc power to the load equipment.
Step 1 - Check dc voltage and polarity
Check the dc output voltage and polarity of the power system.
Step 2 - Connect load equipment
1
2
Step 3 - Check the rectifier currents (some models only)
If a system controller is fitted:
1
2
Procedure complete

Start-Up Completed

Start-Up of the RM3-400/410/420 is now complete and the system is operational.
For information on alarms, or operation problems see Maintenance on page 43.
RM3-410 and RM3-420 Models
For RM3-410 and RM3-420 models the following chapter describes how to use the SC200 or
SC100 system controller. For full details on how to customize the system configuration settings,
and how to setup the remote communications options refer to the System Controller Operation
Handbook (see Related Information on page i).
Switch on the load equipment (refer to the equipment manufacturer's
instructions).
Check the equipment powers up.
Check the rectifier currents.
Verify the load current is as expected for the connected equipment.
Copyright © 2007-2010 Eaton Corporation. All Rights Reserved.
IPN 997-00012-62E June 2010
Start-Up
31