Acls - HP E3800-24G-PoE+-2SFP+ Access Security Manual

Note
Configuring and Using Dynamic (RADIUS-Assigned) Access Control Lists
Configuring the Switch To Support RADIUS-Assigned

ACLs

An ACL configured in a RADIUS server is identified by the authentication
credentials of the client or group of clients the ACL is designed to support.
When a client authenticates with credentials associated with a particular ACL,
the switch applies that ACL to the switch port the client is using. To enable
the switch to forward a client's credentials to the RADIUS server, you must
first configure RADIUS operation and an authentication method on the switch.
1. Configure RADIUS operation on the switch:
Syntax: radius-server host < ipv4-address > key < key-string >
This command configures the IPv4 address and encryption key of a
RADIUS server. The server should be accessible to the switch and
configured to support authentication requests from clients using the
switch to access the network. For more on RADIUS configuration,
refer to chapter 6,"RADIUS Authentication and Accounting".
2. Configure RADIUS network accounting on the switch (optional).
aaa accounting network < start-stop | stop-only > radius
You can also view ACL counter hits using either of the following com-
mands:
show access-list radius < port-list >
show port-access < authenticator | mac-based | web-based > < port-list >
clients detailed
Refer to the documentation provided with your RADIUS server for infor-
mation on how the server receives and manages network accounting
information, and how to perform any configuration steps necessary to
enable the server to support network accounting data from the switch.
3. Configure an authentication method. Options include 802.1X, Web authen-
tication, and MAC authentication. (You can configure 802.1X, Web authen-
tication, and/or MAC authentication to operate simultaneously on the
same ports.)
Configuring RADIUS Server Support for Switch Services
7-35