Table of Contents
Advertisement
Configuring Username and Password Security
Password Recovery
Figure 2-13. Example of the Steps for Disabling Password-Recovery
N o t e
N o t e
2-34
5.
Do one of the following after the "CAUTION" message appears:
•
If you want to complete the command, press
•
If you want to abort the command, press
Figure 2-13 shows an example of disabling the password-recovery parameter.
Password Recovery Process
If you have lost the switch's manager username/password, but password-
recovery is enabled, then you can use the Password Recovery Process to gain
management access to the switch with an alternate password supplied by HP.
If you have disabled password-recovery, which locks out the ability to recover a
manager username/password pair on the switch, then the only way to recover
from a lost manager username/password pair is to use the Reset+Clear button
combination described under "Restoring the Factory Default Configuration"
on page 2-25. This can disrupt network operation and make it necessary to
temporarily disconnect the switch from the network to prevent unauthorized
access and other problems while it is being reconfigured.
To use the password-recovery option to recover a lost password:
1.
Note the switch's base MAC address. It is shown on the label located on
the upper right front corner of the switch.
2.
Contact your HP Customer Care Center for further assistance. Using the
switch's MAC address, the HP Customer Care Center will generate and
provide a "one-time use" alternate password you can use with the to gain
management access to the switch. Once you gain access, you can config-
ure a new, known password.
The alternate password provided by the HP Customer Care Center is valid
only for a single login attempt. You cannot use the same "one-time-use"
password if you lose the password a second time. Because the password
(for "Yes").
[Y]
[N]
(for "No")
Hide quick links:
Advertisement
Table of Contents
