Configuring Radius Accounting - HP E3800-24G-PoE+-2SFP+ Access Security Manual

Note

Configuring RADIUS Accounting

RADIUS Accounting Commands
[no] radius-server host < ip-address >
[acct-port < port-number >]
[key < key-string >]
[no] aaa accounting < exec | network | system > < start-stop | stop-only> radius
[no] aaa accounting commands < stop-only | interim-update > radius
aaa accounting session-id < unique | common >
[no] aaa accounting update
periodic < 1 - 525600 > (in minutes)
[no] aaa accounting suppress null-username
show accounting
show accounting sessions
show radius accounting
This section assumes you have already:
Configured RADIUS authentication on the switch for one or more
■
access methods
■ Configured one or more RADIUS servers to support the switch
If you have not already done so, refer to "General RADIUS Setup Procedure"
in the "RADIUS Authentication and Accounting" chapter of the Access Secu-
rity Guide for your switch.
Steps for Configuring RADIUS Accounting
1. Configure the switch for accessing a RADIUS server.
You can configure a list of up to three RADIUS servers (one primary, two
backup). The switch operates on the assumption that a server can operate
in both accounting and authentication mode. (Refer to the documentation
for your RADIUS server application.)
• Use the same radius-server host command that you would use to
configure RADIUS authentication. Refer to "1. Configure the Switch
To Access a RADIUS Server" on page 6-54.
RADIUS Authentication, Authorization, and Accounting
Accounting Services
Page
6-54
6-54
6-54
6-59
6-61
6-61
6-66
6-67
6-66
6-53