Table of Contents
Advertisement
Configuring Port-Based and User-Based Access Control (802.1X)
General Setup Procedure for 802.1X Access Control
HP Switch(config)# show port-access config
13-14
HP Switch(config)# password port-access user-name Jim secret3
Figure 13-2. Example of the Password Port-Access Command
You can save the port-access password for 802.1X authentication in the
configuration file by using the include-credentials command. For more infor-
mation, see "Saving Security Credentials in a Config File" on page 2-10. in this
guide.
2.
Determine the switch ports that you want to configure as authenticators
and/or supplicants, and disable LACP on these ports. (For more informa-
tion on disabling LACP, refer to the "Note" on page 13-18.).
To display the current configuration of 802.1X, Web-based, and MAC
authentication on all switch ports, enter the show port-access config
command.
Port Access Status Summary
Port-access authenticator activated [No] : Yes
Allow RADIUS-assigned dynamic (GVRP) VLANs [No] : Yes
Supplicant Authenticator Web Auth Mac Auth
Port Enabled
---- ---------- ------------- -------- --------
1
Yes
2
No
3
No
4
No
5
No
6
No
7
No
8
No
9
No
10
No
11
No
12
No
...
Figure 13-3. Example of show port-access config Command Output
Enabled
Enabled
No
No
Yes
No
Yes
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No
Enabled
Yes
Yes
No
No
No
No
No
No
No
No
No
No
Hide quick links:
Advertisement
Table of Contents
