Mount The Cap M To A Wall Or Vertical Surface; Mount A Cap M Using A Single Mounting Bracket - CommScope Era CAP M 9 Installation Manual

Mount the CAP M to a Wall or Vertical Surface

There are two mounting options for the CAP M; follow the procedure that is appropriate for this installation:
"Mount a CAP M Using a Single Mounting Bracket" on page 25
•
"Mount Two CAP Ms Using a Dual Mounting Bracket" on page 31.
•
If this installation requires the optional Hybrid Fiber Splice Box to provide fiber and power to the CAP M,
follow the steps in

Mount a CAP M Using a Single Mounting Bracket

Obtain the CAP M Single Mounting Bracket (CommScope PN 7821955-xx).
1
Follow the steps in "Unpack and Inspect the CAP M and Optional Accessories" on page 19. Table 7 lists the
2
parts that ship with the CAP M Single Mounting Bracket.
Refer to "Determine the Mounting Site" on page 16 to determine the mounting location, which must be
3
able to support the weight and dimensions of the CAP M.
Installer must verify that the mounting surface will safely support the combined load of the electronic
equipment and all attached hardware and components.
Refer to "Mounting Orientation" on page 24 to determine the mounting orientation of the CAP M.
4
Refer to and observe all cautions listed in "General Mounting Cautions" on page 23.
5
M0201AJB
© October 2018 CommScope, Inc.
Table 7. Parts List for CommScope PN 7821955-XX
Description
Single Wall-Mounting Bracket
Quantity
2
™
Era Medium Power Carrier Access Point Installation Guide
Installing CAP Ms
Page 25