On lower right of the CAP M-1, reinstall the M6x12 screw and its washers that you removed in Step 7 on
11
page 33.
Slide first the M6 split-lock washer and then the M6 plain washer over the M6x12 screw.
a
Insert the M6x12 screw through the screw hole shown below, and screw it back into the CAP M-1
b
chassis; torque to 11 N-m.
12 Repeat Step 11 on the left side of the CAP M-1.
M0201AJB
© October 2018 CommScope, Inc.
™
Era
Medium Power Carrier Access Point Installation Guide
Installing CAP Ms
M6x12 screw and
washer set in hole
closest to the
moun ng surface
Page 35